1905-8205 - IBM i Series E4B, 4 GB Single-Port Fibre Channel PCI
The 4 Gigabit Single-Port Fibre Channel PCI-X 2.0 DDR Adapter is a 64-bit address/data, short form factor PCI-X adapter with an LC type external fiber connector that provides single initiator capability over an optical fiber link or loop. With the use of appropriate optical fiber cabling, this adapter provides the capability for a network of high-speed local and remote located storage. The adapter will auto-negotiate for the highest data rate between adapter and an attaching device at 1 Gbps, 2 Gbps or 4 Gbps of which the device or switch is capable. Distances up to 500 meters running at 1 Gbps data rate, up to 300 meters running at 2 Gbps data rate, and 4 Gbps data rate up to 150 meters are supported between the adapter and an attaching device or switch. When used with IBM Fibre Channel storage switches supporting long-wave optics, distances up to 10 kilometers are capable running at either 1 Gbps, 2 Gbps, or 4 Gbps data rates.
The 4 Gigabit Single-Port Fibre Channel PCI-X Adapter can be used to attach devices either directly, or by means of Fibre Channel Switches. If attaching a device or switch with a SC type fiber connector(s), use of an LC-SC 50 Micron Fiber Converter Cable (#2456) or a LC-SC 62.5 Micron Fiber Converter Cable (#2459) is required.
There are two maximum quantities for High Bandwidth adapters, one for performance, and one for connectivity. Adapter performance may be limited by bandwidth constraints in a network. To maximize High Bandwidth adapter performance in the server the performance maximum quantity should not be exceeded. In applications where the end-to-end network cannot sustain high performance and or connectivity is more important than overall bandwidth performance the performance maximum quantity can be exceeded up to the connectivity maximum quantity.
Refer to the following IBM storage subsystem Web page for additional supported server attachment information for IBM devices.
Consult with your IBM representative or Business Partner for additional information relative to any third party attachment.
Attributes provided: 1 Fibre Channel
Attributes required: 1 empty PCI or PCI-X 1.0 / 2.0 slot
For 8202-E4B: (#1905)
Minimum required: 0
Maximum allowed: 24 (Initial order maximum: 0)
OS level required:
AIX Version 5.3 supported
AIX Version 6.1 supported
AIX Version 7.1 supported
SUSE Linux supported
Red Hat Linux supported
Refer to Software Requirements for specific O/S levels supported
Initial Order/MES/Both/Supported: Supported
Return parts MES: Does not apply
Not supported in the CEC
System maximum of 24 in 4 x #5796
Write a reviewName:
Your Review:Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: