Quick Question?
* Name

* Email

Message

* Making Sure You're Not A Robot


Send Message
Your message has been successfully sent!

Give us a call, Toll Free at 888-682-5335

Or Chat with us right now!


iSeries IBM 9406, #4748 PCI RAID Disk Drive / DASD CTLR

iSeries IBM 9406, #4748 PCI RAID Disk Drive / DASD CTLR

(#4748 / #9748) PCI RAID Disk Unit Controller(Only available as REFURBISHED as of July 2, 2002)  The #4748/#9748 is an Ultra2 SCSI controller with a 26MB write-cache that provides RAID-5 protection and compression for internal dis...

Read more about iSeries IBM 9406, #4748 PCI RAID Disk Drive / DASD CTLR

Brand: IBM
Product Code: 4748-9406
Request Price Quote
Qty:



(#4748 / #9748) PCI RAID Disk Unit Controller

(Only available as REFURBISHED as of July 2, 2002)

 

The #4748/#9748 is an Ultra2 SCSI controller with a 26MB write-cache that provides RAID-5 protection and compression for internal disk units (except for the 35GB disk units), and also supports internal tape units and CD-ROM units.

 

#4748/#9748 supports both compression and non-compression modes. The mode of operation is determined by a hardware jumper. #4748/#9748 is shipped in non-compression mode. By moving the hardware jumper the controller will function in compression mode.

 

In addition to providing RAID-5 protection for disks, #4748/#9748 is also designed to work as a high performance controller for disks protected by system mirroring or disks with no protection. In the RAID-5 configuration, disk unit protection is provided at less cost than mirroring, and with greater performance than system checksums.

 

#4748 also supports #4331, 1.6GB Read Cache Device, which provides increased performance. #4331 is supported only when #4748/#9748 is not in compression mode.

 

The #4748/#9748 controller supports a maximum of 18 disk units. A minimum of four disk units of the same capacity are needed for a valid RAID 5 configuration. A maximum of four arrays are allowed per controller, with a maximum of 10 disk units allowed per array. All disk units in an array must be of the same capacity. Parity is spread across four disk units for arrays of four to seven disk units. Parity can be spread across either four or eight disk units for arrays of eight to ten disk units. For systems started with eight to ten disk units in an array, the parity for that array, will be spread across 8 disk units. For systems that are started with fewer than eight disk units in an array and later field upgraded to eight, nine, or ten disk units, the RAID function must be stopped and then started before the parity will be spread across eight disk units. See the Disk Unit Table for a list of disks that can be placed into RAID-5 arrays.

 

The #4748/#9748 controls up to two removable media devices (internal tape or CD-ROM).

 

Prerequisite: Available PCI slot in a base, or feature PCI IOP.

Supported on the following systems: 270, 520, 550, 570, 595, 810, 820, 825, 830, 840, 870, 890

There are no reviews for this product.

Write a review

Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Google+